How to set up Phase with the Pioneer DJM-900NXS2 mixer & Rekordbox DJ
1. Power your Phase via USB or any 5V power supply to turn it on, and plug the RCA cables from the Phase outputs to the Line inputs (1&2 or 2&3 depending on your preference) of your DJM-900NXS2 mixer.
2. Plug the USB from your DJM-900NXS2 mixer to your laptop, and switch the Deck source selector on USB (A or B) to enable DVS Mode.
3a. Open Rekordbox, go to the Audio Settings and select “DJM900-NXS2” in the “Audio Interface Selector”. Then, open the setting utility and set the inputs you are using to “Control Tone Line”. You should also double check the same settings apply to the input channels you are using in the Rekordbox “Input Channels” setting.
3b. Go to the DVS tab in the Rekordbox settings, and make sure the DVS function is activated. When using Phase with Rekordbox, select “CDJs” instead of “Turntables” (in the control hardware tab of the DVS settings).
3c. Make sure to select the audio routing according to the mixer decks you are using (1&2, or 2&3), and that the virtual decks are set on “Relative” mode.
4. Take the Remotes out of the Receiver, put them on your turntables and wait for the calibration to complete (allow the LEDs to turns solid).
5. You are now ready to use Phase with your DJM-900NXS2 mixer and Rekordbox!