Remote linking
We are now going to set up Phase so that the signal can be sent from the Remotes to the Receiver, and from the Receiver to your mixer or DVS interface.
Long press the buttons to link the Remotes
The Remotes are prepared in two steps: linking them to the Receiver, and allowing their internal sensors to calibrate.
Remotes are linked to the Receiver by long-pressing the A and B buttons (3 seconds or so) when placed into the docks. Link them one after the other for troubleshooting purposes, and start with the Remote A. Once the Remote and the button’s LEDs start flashing, the buttons can be released: the blinking means the Remote has been successfully linked. You’ll also notice that the A and B buttons now match the color of the Remotes’ LED strip.
If you cannot link your Remotes to the Receiver, click here.
If you successfully linked the Remotes, click on the button below to proceed to the next step.